Roland Double Sided Milling Tape
Double sided tape for holding material firmly in place during milling, engraving, and pc board cutting.
We’ve tested many different types of double sided tape, and this tape outperformed them all. When you peel the tape off of your part, the adhesive stays on the tape, not your part.
Tape is 1/2" Wide x 108' in length
If you are in a bind for tape, you could go to your local store and buy a double sided carpet tape, this also works well, however it sometimes leaves a residue behind.
We never recommend using the double sided foam tape it is very hard to remove and also allows your part to move around while it is being cut.
Use with the Roland MDX-540SA, MDX-540S, MDX-540A, MDX-540, MDX-50, MDX-40A, MDX-40, SRM-20, MDX-20, MDX-15