Knowledge Base:  
Why do I sometimes get the lines across my model wax and another materials?
Last Updated 1/31/2008

Lines come from the finish tool I assume and it is the conical tool, I think the tool tip might have been broken of and is not not perfectly flat at the tip imagine a break and this when cut through the wax does not give you a flat cut.

If it is not a jewelry tool instead maybe and 1/8" flat tool then the tool might have not been manufactured correctly. Check your tool under a magnifying glass and look to see if either of the 2 issues are there.



Was this article helpful?

Comments:
 

Related Articles
 > MDX-40 Cancel Print
 > Port Not Ready, MDX-15, MDX-20, LPX-250, PIX-4, PIX-30, Dr Picza, Dr Picza 3
 > Can the MDX machines cut Steel/Stainless Steel/ Titanium?
 > Do I need to do ROUGHING passes with each tool?
 > Do I need a different tool to do engraved and standing letters in wax?
 > Do I need to change a parameter in Modela Player 4 to get better fine lines and detail in my jewelry wax?