|
|
Can the MDX machines cut Steel/Stainless Steel/ Titanium?
The MDX series machines were made for an office environment and with that in mind have no coolant system, I do not recommend cutting these materials at all. The reason is that when cutting these mate |
Do I need a different tool to do engraved and standing letters in wax?
No to do the engraved letters in wax or embossed letters, if they are modeled in the 3d model then the machine will cut them out, just use the conical tool and it can get in and around all of the det |
Do I need to change a parameter in Modela Player 4 to get better fine lines and detail in my jewelry wax?
For doing jewelry work with the conical tool I recommend a step over of .0015 inch it takes a little longer to cut but gives you a better surface finish on your wax and also gets in and around all the |
Do I need to do ROUGHING passes with each tool?
When I rough it does not cut out the small holes and then when I finish the small tool goes into the hole and gets broken why?
3 different scenarios to consider with this question
Soft |
MDX-40 Cancel Print
MDX-40 Cancel Print
To cancel a print on the MDX-40 you need to first select the VIEW button on the front of the MDX-40
Next you need to open the MDX-40 printer folder
Once you have the printer |
Port Not Ready, MDX-15, MDX-20, LPX-250, PIX-4, PIX-30, Dr Picza, Dr Picza 3
Port Not Ready Error, MDX-15, MDX-20, LPX-250, PIX-4, Pix-30
Here is the procedure to help get the scanner or milling machine to connect when the Port not ready error occurs.
|
Why do I sometimes get the lines across my model wax and another materials?
Lines come from the finish tool I assume and it is the conical tool, I think the tool tip might have been broken of and is not not perfectly flat at the tip imagine a break and this when cut through |
|
|
