Knowledge Base:  
Do I need a different tool to do engraved and standing letters in wax?
Last Updated 1/31/2008

No to do the engraved letters in wax or embossed letters, if they are modeled in the 3d model then the machine will cut them out, just use the conical tool and it can get in and around all of the detail as needed. Nothing except normal cutting is required.



Was this article helpful?

Comments:
 

Related Articles
 > MDX-40 Cancel Print
 > Port Not Ready, MDX-15, MDX-20, LPX-250, PIX-4, PIX-30, Dr Picza, Dr Picza 3
 > Can the MDX machines cut Steel/Stainless Steel/ Titanium?
 > Do I need to do ROUGHING passes with each tool?
 > Why do I sometimes get the lines across my model wax and another materials?
 > Do I need to change a parameter in Modela Player 4 to get better fine lines and detail in my jewelry wax?